Problem in transmitting data through the RN2483-Arduino library

[marco-omniabit]

I connected the module directly to the Arduino Mega. In practice I followed this guide:

How to build your first TTN node: Arduino + RN2483

There is a lot of information distributed across this forum on how to build nodes for TTN. I’m going to summarize how I built my first TTN node using an Arduino Uno and an RN2483 radio module. See this as a “How to get started” tutorial for first time builders. There are a lot of things this design can improve on, but this is at least a good place to start. What you will need: Arduino Uno (an Arduino Nano, or any other ATmega 328p, or Arduino compatible board should work too) Microchip RN248…

with the only difference that I did not directly connect the cables to the modem but to the module on which it is embedded.

Thank you