Received APPEUI and APP KEY from Supplier (not available from the manufacturer) make sure to also ask for Netvox payload document as not on manufacturer web site (same doc for all netvox gear).
Device worked straight away
Payload:
Port 6
type : [version] [device type] [Report Type] [Netvox Payload Data ]
bytes : 1 1 1 8
value: 01 02 01 1E 00 000000000000 open
value: 01 02 01 1E 01 000000000000 closed
Type : [Netvox Payload Data] [Netvox Payload Data] [Netvox Payload Data]
[Battery Voltage :1 ] [Close/Open :1 ] [Reserverd :6 ]
1E 00 00 00 00 00 00 00
1E 01 00 00 00 00 00 00
Downlink:
Port 7
RR DD NN NN XX XX BB
01 02 00 01 01 2C 01
RR = Request Type
DD = 02 R311A device type
NN NN = 2 bytes: minimum reporting time Sec, factory default 00 01
00 01 = 1 Sec
XX XX = 2 bytes: maximum reporting time Sec, factory default ?? ??
01 2C = 300 Sec
BB = Battery voltage change report rate in 0.1V units
Still unclear how MaxTime is being used, as minTime definitely affects report rate
Still at a loss as to why there’s 2 buttons on the side of the unit, as the user manual does not differentiate between them. ??
But there’s no Join, and no data is seen in Console.
How you manage to make them work with TTN?
I set-up the Conduit GW with the embedded NetworkServer using Node-Red and the devices worked well! They join the Network and I can see data coming… So what’s the issue when trying to connect with TTN? Any advice?
I do have the APP Keys and EUIs:
-APP KEY: 5A-69-67-42-65-65-41-6C-6C-69-61-6E-63-65-30-39
-APP EUI: 00-13-7A-10-00-00-00-00
[They are all the same for all devices I bought]
Sorry, but where I must “load” the encoder and decoder?
Which is the issue here? Why they don’t work wiht TTN?
– Do you accept a good wine instead? (I’m from Argentina)
Yes, I used an Evaluation Board from Multitech and works OK.
NO. No data coming into the console.
YES, I made factory reset. You mean this “reset” makes the device not compatible or disarranges it.
The only additional information I got was the log from TTN, that shows a “msg error type”:
router_1 | 2019-06-14T20:04:01.690156792Z WARN Invalid Uplink error=Message not valid: Protocol not valid: MType not valid: unknown type 7
router_1 | 2019-06-14T20:04:23.806420891Z WARN Invalid Uplink error=Message not valid: Protocol not valid: MType not valid: unknown type 7
router_1 | 2019-06-14T20:04:28.403443777Z INFO Handled gateway status Duration=9.028µs GatewayID=semak1
router_1 | 2019-06-14T20:04:46.900075479Z WARN Invalid Uplink error=Message not valid: Protocol not valid: MType not valid: unknown type 7
Any advice on this msg?
I’m trying to get a reply from manufacturer as well…